These lecture notes and
tutorials are licensed under a Creative Commons
Attribution-ShareAlike 4.0 International License.
2019 Summer session - UNIGE
Introductory
OpenFOAM training
This offering is
not approved or
endorsed by OpenCFD Limited, the producer of the OpenFOAM software and
owner of the OPENFOAM and OpenCFD trade marks.
Dates:
The course was held from July 8 to July
12, 2019.
Location:
University of Genoa. DICCA.
1, Via Montallegro
16145 Genoa, Italy
For
more information about the next training session, advanced and
personalize training, visit the training section of our university spin-off site www.wolfdynamics.com/our-services/training.html
If
you are interested in CFD/Multiphysics simulations, optimization, data analytics, and
exploratory data analysis
consulting or mentoring, visit our
university spin-off site www.wolfdynamics.com
Hey, where did the training material go?
The 2019 summer session slides were revised and new
tutorials where added.
You can find the latest training material in the following link:
http://www.wolfdynamics.com/our-services/training/openfoam-intro-training.html?id=163
If you
are new to linux and you do not want to go thru the hustle and
bustle of installing it, partioning your hard drive, and installing all
the applications for CFD, CAD, meshing, visualization and optimization
(OpenFOAM
included), we recommend you to install Linux
Opensuse Leap 15.1 using a virtual machine. To
install the virtual machine you can use VMware Workstation Player (free for
non-commercial, personal and home use). Alternatively, you
can use virtualBox
(opensource).
joel.guerrero@unige.it
