Issues related with parallel computations: differenze tra le versioni
| Riga 2: | Riga 2: | ||
The following instructions were carried aout on version v7p0 of open-telemac. | The following instructions were carried aout on version v7p0 of open-telemac. | ||
| + | |||
| + | Open the parallel prompt and run | ||
| + | |||
| + | ''compileTELEMAC.py'' | ||
| + | |||
| + | If it works you have just accomplished your job, otherwise go on reading. | ||
Once you open the prompt for parallel computations you can run your model in the usual way ([[Run a case]]). However, the simulation will start only if the appropriate binaries have been compiled and are present in the appropriate folder inside the path "v7p0/builds". This was not my case. | Once you open the prompt for parallel computations you can run your model in the usual way ([[Run a case]]). However, the simulation will start only if the appropriate binaries have been compiled and are present in the appropriate folder inside the path "v7p0/builds". This was not my case. | ||
Versione delle 11:31, 10 giu 2016
After installing the "Automatic Installer" in Windows (Installation using "Auto Installer") you get two different prompts: one for scalar computations and another for parallel computations.
The following instructions were carried aout on version v7p0 of open-telemac.
Open the parallel prompt and run
compileTELEMAC.py
If it works you have just accomplished your job, otherwise go on reading.
Once you open the prompt for parallel computations you can run your model in the usual way (Run a case). However, the simulation will start only if the appropriate binaries have been compiled and are present in the appropriate folder inside the path "v7p0/builds". This was not my case.
In order to solve this issue take a look at the following links:
http://www.opentelemac.org/index.php/kunena/18-artemis/9309-parallel-creocean-example#21961
http://www.opentelemac.org/index.php/kunena/2-windows-version/7980-telemac-parallel#17589
The procedure I followed is this:
1) download the file "systel.parallel.cfg" from the link above and save it into the folder "v7p0/configs";
2) open the file and, in case, change the root-path;
3) go inside the folder builds and run in the parallel prompt
compileTELEMAC.py -f path_to_your_folder/v7p0/configs/systel.parallel.cfg -c wing64mpi
4) everything should be compiled;
5) now yoy can run in parallel using the command
artemis.py -f path_to_your_folder/v7p0/configs/systel.parallel.cfg your_file.cas
